Eau Claire, WI · Northwestern Wisconsin Closed now (715) 450-9897

Parking Lot Striping in Bloomer

Parking Lot Striping in Bloomer, Wisconsin.

Parking lot striping and line painting in Bloomer: restripes, new layouts, ADA stalls and fire lanes.

4.7 from 18 Google reviews

About 30 minutes north of Eau Claire. Free estimates, and a straight read on whether it needs doing yet.

An overhead view of a freshly sealed parking lot with new yellow stall lines and marked ADA stalls.
3,646 People in Bloomer
4.7 Google ratingFrom 18 reviews
2-3 yrs Reseal cycleIn Bloomer
400°F Crack fillerDirect-fire rubber

What a Parking Lot Striping Job Looks Like in Bloomer

There are two commercial zones and they behave differently. Main Street is the historic downtown, tight lots with shared access and on-street parking, where the jobs are small and access is tight.

The highway strip along Seventeenth and Nineteenth Avenue is the other one: modern retail, larger lots, purpose-built parking and room to work. Bloomer also carries real medical parking for a town this size, on more than one street, plus industrial ground on the edges. Those are the square-footage jobs.

Parking Lot Striping specifically in Bloomer

Bloomer carries more medical parking than a town of 3,700 usually does, and on more than one street. Medical lots have the least forgiving accessible-stall requirements of anything we stripe: the stall width, the access aisle beside it and the route to the door all have to be right rather than close. We measure before painting rather than tracing what faded, which is how a lot loses a stall a year without anyone noticing.

The Driveways and Lots in Bloomer

Bloomer sits north of Chippewa Falls where Highways 40 and 64 cross, the largest town in the northern half of the service area and the one most of the smaller places up there drive to.

Bloomer is the most evenly built town in the service area. No single decade carries it: about a third of the stock predates 1960, but nearly a quarter has gone up since 2000, and every decade in between is represented.

That matters more than it sounds. In a town built in one burst, the driveways all fail together and the advice is largely the same. In Bloomer the house next door can be thirty years older than yours, and what its drive needs isn't what yours needs. We quote them separately rather than by neighborhood.

Bloomer

We work the whole village rather than a named handful of neighborhoods.

Around Bloomer: Main Street, Highway 40 and 64 junction, Bloomer Middle School.

Standard 48-inch frost depth, and far enough north that spring opens a week later than it does in Eau Claire.

From our jobs

Job Photos

Fresh yellow stall lines crossing a newly sealed parking lot, deep black surface
Yellow layout, back on over fresh sealer
A freshly sealed and striped commercial lot from above, the company flatbed parked on it
A commercial lot, sealed and striped
Freshly sealed and striped school parking lot
A school lot, sealed and striped

All job photos

Layout first, then paint

Repainting existing lines is the easy half. The half that matters is whether those lines were right in the first place, and on a lot that's been restriped three or four times by different crews, they usually have drifted. Stalls narrow by an inch each time somebody paints beside the old line rather than over it, drive aisles shrink, and eventually a delivery truck can't make the turn. We measure before we paint. Sometimes that means telling you the layout you have fits fewer cars than the layout you could have, which is a conversation worth having before the paint goes down rather than after.

What Decides the Price in Bloomer

Priced per stall for straightforward restripes, or as a lump sum where there's layout work, ADA work or a lot of detail.

New layout

Per stall, measured and set out

Measured on site

  • Where the layout has drifted or the use has changed

ADA stall with access aisle

Each

Measured on site

  • Stall, hatched access aisle and symbol
  • Signage and post priced separately if needed

Detail work

Arrows, fire lanes, numbers, crosswalks

Measured on site

  • Priced per item
  • Stencils and custom legends available

Striping done at the same visit as sealcoating costs less than striping done on its own, because the trip is already paid for and the surface is already right. If both are due, do both.

How the Work Goes in Bloomer

Planned with you before the first stripe goes down.

Measure what's there

Stall widths, aisle widths, the accessible stalls and their aisles. This is where drift shows up, and it's a five-minute job that avoids repainting a layout that has quietly stopped working.

Clean the surface

Blown down. Paint over grit is paint that comes up with the grit, usually the first time a plow goes over it.

Lay out and chalk

Anything other than a straight restripe gets set out and chalked first, so you can look at it before it's permanent.

Paint

Traffic paint at the right film thickness. Thin paint looks the same on the day and is gone in a season, which is the striping equivalent of a thin seal.

Open it back up

Traffic paint is dry to walk on in under an hour. How long before cars go back on it depends on the paint and the weather that afternoon, so you get the real number on the day.

Questions We Get in Bloomer

What Bloomer calls us about, answered straight.

More questions answered
When does the season actually start up here?
About a week later than it does in Eau Claire, and it closes a little sooner at the other end. Sealer needs the surface dry and the overnight temperature to stay up, and thirty minutes north is enough to move both. The practical answer is that fall work booked ahead beats waiting on a northern April.
Can you work a Main Street lot without closing us for the day?
Usually, but it's the first thing to talk about rather than the last. The downtown lots here are tight with shared access, so a section at a time is often the only way to keep a door open. Sealer needs about 24 hours before traffic goes back on it, and that's the constraint the schedule gets built around.
Is Bloomer far enough north that the drive costs us something?
Bloomer is about thirty minutes north and it's well inside the area we work. The estimate is free, and the number you approve is the number you pay.
How much does it cost to restripe a parking lot?
It is priced per stall, and the thing that moves it most is whether the old lines can be followed. A straightforward restripe over a layout that is still visible is the cheap end. A new layout costs more per stall because it has to be measured and set out from scratch. ADA stalls cost more than standard ones: they are wider, they carry an access aisle and they need the symbol and the signage.
How often does a lot need restriping?
Every one to three years in Bloomer and the surrounding area, depending on traffic, plowing and sun. Lots that get plowed hard lose lines fastest, because the blade takes the paint with the snow. If your accessible stalls are hard to read from a car, it's due.
Do you handle ADA compliance?
We mark accessible stalls, access aisles and symbols to the required dimensions and can advise on stall counts and signage. We're a paving contractor rather than a compliance consultant, so for a formal audit you want a specialist, but for getting the markings right we do this constantly.
Should we seal before striping?
Yes, and in that order, at the same visit. Sealer covers existing lines, so striping first wastes the paint. Doing both together also costs less than two separate visits.
Can you do stencils, numbers and custom legends?
Yes. Arrows, fire lane markings, no parking, loading zones, reserved stall numbers, crosswalks and custom text.
Do you stripe anything other than parking lots?
Yes. We stripe running tracks and sports courts, which is measured layout work at a different level of precision. It's on our athletic surfaces page.

Get a Free Estimate in Bloomer

Tell us what it looks like and we'll come measure it. You get a written price before anything starts.

(715) 450-9897
  • Free on driveways and lots anywhere in the service area
  • A photo of the problem helps, and it can go in the message
  • Surfaces that are not ready yet get told so at the estimate

Get an estimate

Send the form and we'll call you back. The estimate is free.