Eau Claire, WI · Northwestern Wisconsin Closed now (715) 450-9897
(715) 450-9897

Crack Filling and Sealing in Durand

Crack Filling and Sealing in Durand, Wisconsin.

Hot rubber crack filling for driveways and lots in Durand, before the freeze does the expensive part.

Get a Free Estimate Call (715) 450-9897

4.7 from 18 Google reviews

About 40 minutes southwest of Eau Claire. Free estimates, and a straight read on whether it needs doing yet.

A web of freshly filled cracks running across a parking lot, the rubber still glossy.
1,873 People in Durand
4.7 Google ratingFrom 18 reviews
2-3 yrs Reseal cycleIn Durand
400°F Crack fillerDirect-fire rubber

What a Crack Filling and Sealing Job Looks Like in Durand

The commercial base here's county and civic rather than retail: courthouse, county offices, a hospital, schools, and the businesses that serve them. Those are steady lots with predictable use and real accessible-parking obligations, which is a different profile from a highway strip.

Durand is also the furthest point southwest we cover, so we batch work here rather than running single small jobs out and back. If you have neighbors thinking about it, say so when you call. Several drives on one trip is genuinely cheaper to deliver, and that shows up in the number.

Crack Filling and Sealing specifically in Durand

On stock this age, crack filling is often the entire job. Hot rubber into everything that has opened will buy several years on a drive that's otherwise solid, for a fraction of what replacement costs.

The Driveways and Lots in Durand

Durand is the Pepin County seat, on the Chippewa River near where it runs down toward the Mississippi, and the southwest corner of what we cover. County seat is the operative fact: it carries a courthouse, county offices and a hospital for a population of 1,854.

Durand has the oldest housing stock of any town we work in. Fifty-six percent of it predates 1960 and roughly a quarter predates 1940. Fewer than fifty units in the entire city have been built since the year 2000, and only a handful went up in the whole of the 2010s.

That changes what an honest quote looks like here. A drive that's been in the ground since the fifties, over a base that predates any modern specification, is not automatically a sealing job. Sometimes it's. Sometimes the truthful answer is that sealer over a failed base is money spent on appearance, and we would rather tell you that than take it.

Durand

We work the whole village rather than a named handful of neighborhoods.

Around Durand: Pepin County Courthouse, Chippewa River, Durand-Arkansaw schools.

Standard 48-inch frost depth. River-valley position, so cold settles overnight and the shoulder seasons have a narrower working window than the flat ground upriver.

From our jobs

Job Photos

The crack crew's trucks and melter working a tree-lined road, road work sign up
The crack crew working a town road
The company flatbed and the yellow crack-seal melter on a road shoulder, two crew in hi-vis working ahead of it
The melter on site, crew working ahead of it

All job photos

Hot rubber vs. cold pour

The stuff in a jug at the hardware store is cold pour. It goes in as a liquid, dries, shrinks, and sits in the crack like a rubber band laid in a trench. It's not bonded to anything. The first hard freeze pulls the crack open, the filler has nothing holding it to the walls, and it lifts out in a strip. Most people have seen this happen and assumed it was a bad batch. Hot-applied rubber goes in at around 400 degrees. At that temperature it's thin enough to run down into the crack instead of bridging it, and hot enough to melt into the asphalt faces on either side. When it cools it has bonded to the walls of the crack, so when the crack moves, the filler moves with it.

Cold pour

The jug from the hardware store, and what a cheap quote uses

  • Sits in the crack rather than bonding to it
  • Shrinks as it cures, leaving a channel down the middle
  • Pulls out in strips after the first hard winter
  • Cheap enough that it gets redone every year, which isn't cheap

Hot-applied rubber

What comes off our kettle

  • Flows to the bottom of the crack at 400 degrees
  • Melts into the asphalt faces and bonds to both walls
  • Stays flexible, so it moves when the crack moves
  • Holds for years, not for one season

This is the one place where the cheaper option isn't a smaller version of the right one. It's a different product doing a different thing.

What Decides the Price in Durand

Priced by the foot of crack, not by the area of the surface, because that's what actually drives the work. Usually done as part of a sealcoating job, where it costs less than it would on its own.

With a sealcoat job

Driveway

Measured on site

  • Most driveways need some, and it's included up to a point
  • Heavy cracking is quoted separately and said up front

Crack filling alone

Driveway, no sealcoat

Measured on site

  • Worth doing on its own if the surface is otherwise sound

Commercial lot

Per linear foot

Measured on site

  • Depends on crack width, depth and how much routing it needs
  • Most lots are quoted as a lump sum after a walk

Cracks wider than about an inch and a half, or ones that have broken into a network, are past filling. Those get cut out and patched rather than filled with something that will not hold.

How the Work Goes in Durand

Done before sealer, always: sealer can't bridge an open crack.

Clean the crack out

Blown out with compressed air, vegetation and old failed filler removed. Rubber won't bond to dirt any more than sealer will.

Rout the wide ones

Wide or heavily worked cracks get cut to a consistent reservoir so the filler has a proper shape to sit in. Not every crack needs it; the ones that do are the ones that have already failed once.

Fill hot

Direct-fire kettle, rubber at 400 degrees, wanded into the crack until it's full from the bottom up rather than skinned over at the top.

Squeegee and let it set

Struck off flush or slightly banded over, depending on the surface. Sets hard enough to drive on in under an hour in most conditions.

Booking sealcoating and striping through October · Call (715) 450-9897

Questions We Get in Durand

What Durand calls us about, answered straight.

More questions answered
The house is from the 1940s and so is the driveway. Where do we start?
With whether there's a base worth building on. That's a five-minute look, and it decides everything after it. If the surface is solid underfoot and simply gray and cracked, crack filling and sealing will genuinely extend it. If it moves when you stand on the broken areas, no surface treatment will hold.
Do you come this far out for one driveway?
Yes. If a neighbor or two want theirs looked at, mention it when you call: several jobs on one trip come down per job.
Does being down in the river valley change when you can work here?
It narrows the day rather than the season. Cold air settles in the Chippewa valley overnight, so an early-spring or late-fall job in Durand has fewer usable hours in it than the same date would on the flat ground upriver. It does not rule the work out. It does mean the date is worth settling early rather than assuming, especially at this end of the area.
How much does crack filling cost?
It is priced by the linear foot of crack rather than by the size of the surface, so a big driveway with four cracks costs less than a small one that has opened up all over. Width matters too: anything wide enough to need routing out first takes longer. On a driveway it is usually included up to a point when it is done with a sealcoat rather than billed on its own.
Why does the temperature of the crack filler matter?
At 400 degrees the rubber is thin enough to reach the bottom of the crack and hot enough to melt into the asphalt on both sides, so it bonds. Cold pour filler can't do either, which is why it lifts out in strips after a winter.
Should I fill cracks before sealcoating or after?
Before, always. Sealer is a thin wear layer and it can't bridge an open crack. Sealing over one changes its color and nothing else, and the crack reappears through the new surface within weeks.
Is there a crack too big to fill?
Yes. Past about an inch and a half, or once cracking has broken into a network of squares, filling won't hold because the surface around it is moving independently. Those areas get cut out and patched instead.
When is the best time of year for crack filling?
Spring or early fall in Durand and the surrounding area is ideal, because cracks are at a middling width. In high summer they're at their tightest and in deep winter they're at their widest, and filling at either extreme means the filler is working against the movement rather than with it.

Get a Free Estimate in Durand

Tell us what it looks like and we'll come measure it. You get a written price before anything starts.

(715) 450-9897
  • Free on driveways and lots anywhere in the service area
  • A photo of the problem helps, and it can go in the message
  • Surfaces that are not ready yet get told so at the estimate

Get an estimate

Send the form and we'll call you back. The estimate is free.

By submitting, you agree to be contacted about your crack filling and sealing job. Text messages only go out if you checked the box above. We don't sell your info, ever.

Other Work We Do in Durand

Crack Filling and Sealing in Nearby Towns

Everything about crack filling and sealing, including how the work goes and what changes the price